Committee of Adjustment

A. THAT Application A31/2021 requesting relief from By-Law No. 122-2020 to permit a separation distance of 390 m between a Cannabis Production and Processing Facility from residentially zoned lands, whereas a separation distance of 400 m is required, BE APPROVED, contingent on By-law No. 122-2020 coming into force and effect; and B. THAT the reason(s) for approval are as follows: the proposed variance is in keeping with the general intent of the Official Plan and Zoning By-law, the relief requested is considered minor in nature and is desirable for the appropriate development and use of the land; and C. THAT pursuant to Section 45(8) – (8.2) of the Planning Act, R.S.O 1990, c.P.13, the following statement SHALL BE INCLUDED in the Notice of Decision: “Regard has been had for all written and oral submissions received from the public before the decision was made in relation to this planning matter, as discussed in Section 6.2 of Report No. 2021-572.” Recorded vote on Item 3.1: YES: Krystyna Brooks, Tara Gaskin, Virginia Kershaw, Lee Rynar, Gregory Kempa, Michael Bodnar. Dan Namisniak – 7 NO: None – 0 Item 3.1

A. THAT Application A32/2021 requesting relief from Section 6.19.6.1 of Zoning By-law 160-90 to permit utility service equipment (electrical transformer) to not be screened on all sides by an opaque fence and/or wall of a minimum height equal to the height of the utility service equipment to a maximum of 4.0 m, or a buffer approved pursuant to the Site Plan Control provisions of the Planning Act, whereas when utility service equipment is located on a lot and not enclosed, and is greater than 1.4 m in height, such equipment shall be screened on all sides by an opaque fence and/or wall of a minimum height equal to the height of the utility service equipment to a maximum of 4.0 m, or a buffer approved pursuant to the Site Plan Control provisions of the Planning Act is required, BE APPROVED; B. THAT Application A32/2021 requesting relief from Section 6.19.6.2 of Zoning By-law 160-90 to permit utility service equipment (electrical transformer) to be located 2.2 m from either a lot in a Residential Zone or a lot line abutting a street, whereas when a utility service equipment is located on a lot and not enclosed and is greater than 1.4 m in height, such equipment shall not be permitted within 6.0 m of either a lot in a Residential Zone or a lot line abutting a street is required, BE APPROVED; C. THAT the reason(s) for approval are as follows: the proposed variance is in keeping with the general intent of the Official Plan and Zoning By-law, the relief requested is considered minor